Product Overview
POSH SR400/500 CLUTCH CABLE, STANDARD LENGTH - 010112-CL (010012-CL).
The POSH STANDARD length clutch cable suits all SR models (78~18). The standard length CLUTCH cable is use with standard / factory bars of (83/18 models) and with custom (non genuine) aftermarket bars that are of a similar dimension.
DETAILS:
- SUITS: SR400/500 - All years (*see cable length notes below)
- Cable outer is black outer, inner wire is stainless
- Supplied with a genuine Yamaha lever cover boot
- Made in Japan
*Cable here is classified as the standard length, this refers to the length used on the SR400/500 built between (83~18) with genuine type bars. Earlier 78~82 models in some regions had "wide bars". For early models bikes with "wide bars" the +100mm length allows for a good fit. However if your bike is an early model (PRE 83) and you have swapped the bars to later model bars or similar custom bars (smaller than the larger early 78~82 wide bar) then this cable is still able to be used.
XT500 use is possible, but again consider this is the STD length for std 83-18 SR bars, it will be shorter than the XT std cable due to the different bars and forks, but if you have low bars on your XT, it may be a solution for your build.....
NOTE: Cables should be lubed at time of fitment. Fitting should be carried out by a qualified experienced mechanic's as per the factory workshop manual. Cable should always be tested before use on road to ensure the pull & return function is uninhibited and cables have correct free play adjustment. We recommend making sure your clutch is in good order and adjusted correctly. Cable fits with SR lever, if you have made changes to the Clutch lever ensure it is compatible with SR spec clutch cables.
