Product Overview
The DAYTONA SR400/500 CLUTCH CABLE (-100mm) - PART NUMBER 30175 suits all SR models (78~18).
The short length CLUTCH cable is for use with clip on bar specification or low clubman type bars. In some cases it is also used with narrow drag bars. This cable also has a mid way adjuster. End fittings are correct for the SR throttle / switch block, and engine holder.
- Suits: SR400/SR500 (78~08) & SR400FI (10 ~18) suitable for clip on bar use and some low bars or lowered bikes
- Length: -100mm SHORT (- 100mm shorter than standard)
- Material: Black PVC outer, Stainless wire, Steel fittings
- Other: Made in Japan
The Length of this cable is referred to as -100mm (short). Some early model bikes had "wide bars". In that case the cable may be shorter than -100mm. If unsure of suitability, consider that the cable is for clip on bar use (or similar low bars), also often used on low hanging clubman bars, Ace bars, narrow drag bars etc.
NOTE: Always ensure your clutch is adjusted correctly and the clutch and related parts are in good working order. Cable should be lubed when fitting and ends should be greased. Ends are made for the factory clutch lever, If you have made changes to the clutch lever ensure it is suitable for use with SR clutch cables. If unfamiliar with the replacement process check your workshop manual, if in doubt have a professional licensed mechanic fit the cable for you.
