Product Overview
DAYTONA 85mm UP SCRAMBLER BAR, W/CROSS BRACE, CHROMED, 26807
The Daytona chromed Scrambler bar (26807) with 85mm rise is a long-time seller in our store. Without a doubt this is one of the best Scrambler / Tracker style vintage inspired bars available for street bikes such as the SR400/500, XS650 & W800/W650. Also often used on Triumph builds (on bikes with 22.2mm spec).
Specifications:
- Size: 830mm wide x 85mm high x 147mm PB
- OD: 22.2mm, (7/8”)
- ID: 19mm
- PB = pull back (AKA: sweep)
Features:
- Made from high strength steel, to meet JIS standards.
- Low wide bar, with cross brace, great for Scrambler builds.
- High quality chrome finish, with stamped Daytona logo.
- Relaxed bend style that suits many bike models.
- Universal use on a range of bikes with 22.2mm bars (7/8")
- Made in Japan to ensure quality is maintained.
*For the SR400/500,
See our SR kits using this "SCRAMBLER BAR" bar, supplied with all required cables.
Or check cable recommendations below. Shown is STD and then required/recommended length.
- Brake Cable: STD =1080mm, > change to +200mm (p.n 22358)
- De-Comp: STD = 671mm > change to: +120mm (p.n 22356)
- Throttle: STD Push = 1010mm, STD Pull = 1060mm > change to: +120mm (p.n 22355)
- Clutch: STD = 975mm, > No change (use original) or replace with 010112-CL or (010111-C1)
- Wiring harness: > No change (use original)
- Brake Line: STD =780mm, > change to +220mm (p.n 60578) *1000mm A spec
- De-Comp: STD = 671mm > change to: +120mm (p.n 22356)
- Throttle: STD Push = 990mm, STD Pull = 990mm > change to: +120mm (p.n 39885)
- Clutch: STD = 975mm, > No change (use original) or replace with 010112-CL or (010111-C1)
- Wiring harness: > No change (use original)
Attention:
- Please see specs above for details.
- This bar is 22.2mm. If using on the W650, you will need to purchase shims separately.
- See part number 26752 (2x sets are required for the W650).
- Due to the size and width of this bar, you may require longer cables, and brake line depending on your bike model and year model.
- Bars are a general-purpose handlebar. To install, it might be necessary to drill a hole for the left and right switch boxes or notch the bar, (eg: W650/800 etc.).
- As these are a universal bar, please check the specs above and ensure these will fit your clamp width, throttle, use & application etc.
- If you have a bike with 1inch bars and require 25.4mm (1") to 22.2mm (7/8") shims, see our handlebar shims (26752).
