Product Overview
DAYTONA HIGH SPEC BRAKE LINE, STAINLESS (850mm), DOT MARKED, (TYPE: D SPEC), 60595.
The HIGH SPEC line by DAYTONA is a stainless line with a neoprene outer to resist the elements (oil, sun, water etc.). Banjo ends are steel. The lines are DOT marked and tested, they pass and exceed the FMWS.106 (Federal safety Standard). Suits universal use on a range of models. Made in Japan to the highest standards. For repair, upgrade, or use with custom builds requiring this length line. See the compatibility table image for models using the 850mm long D spec.
Details:
- Banjo material: Steel
- Banjo thickness: 8mm
- Inner hose layer: Teflon
- The hose banjo fitting is crimped to guarantee sealing, safety and performance.
- Please use with the correct size banjo bolts, we recommend GOODRIDGE banjo bolts (sold separately)
- Made in Japan
Example of models using this line:
W650 use: This line is the same length as the "Low bar model" brake line. The W650 low bars model used an 850mm (D) type line. Use this line on the W650 low bar model as an upgrade or replacement. Or use with custom bars such as the "Conti" bar, "Touring" bar or "UK" (aka - English) bar. Often used on the W800 and W400 when fitting W800 Touring bars. Check length to ensure suitability with your handlebars set up. For W650 high bar, or W650 using Tracker bars or W1 bars, see the 1000 D brake line.
SR400/500 use: This particular line suits the factory SR400/500 (EARLY MODEL) master cylinder and LHS caliper (as well as others models such as the XS650). For the SR it fits all early model (78~85) with LHS front caliper. *Always measure to ensure suitability with your chosen bars.
General information:
Hose type: Two types of lines are available (A spec & D spec). The spec type refers to the banjo fitting angle in relation to each end. Lines are available in 50 mm increments and are set from 550 mm to 1050 mm to fit a wide range of models.
Type A: Banjo 21 ° & straight Banjo - (no turn, banjo faces the same direction at each end)
Type D: Banjo 21 ° & straight Banjo - (with a 90 ° turn compared to the other end)
Note: Always use new gaskets (washers) when fitting this line, and always ensure the banjo bolt is compatible with the line fittings. Changing any component on your brake system requires a very high level of experience and skill. This line should only be fitted by a licensed qualified mechanic in licensed workshop. The brake system will require bleeding before use, bleeding of the system should only be carried out by qualified mechanics.
